Observe these precautions when installing the Cognex product, to reduce the risk of injury or equipment damage:
To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic discharge (ESD), power surges, or other irregularities in the power supply, route all cables and wires away from high-voltage power sources.
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the user’s authority to operate the equipment.
Cable shielding can be degraded or cables can be damaged or wear out more quickly if a service loop or bend radius is tighter than 10X the cable diameter. The bend radius must begin at least six inches from the connector.
This device should be used in accordance with the instructions in this manual.
All specifications are for reference purpose only and may be changed without notice.